Autoadapt TURNY evo Benutzerhandbuch Seite 27

1 Lifting motor overloaded.
2 Fault on pulse sensor for lifting motor.
Pinch protection actuated for rotation motor. In the
event of any obstruction, Turny will stop and re-
verse a short distance.
Pinch protection actuated for lifting motor. In the
event of any obstruction, Turny will stop and re-
verse a short distance.
Pinch protection actuated for lengthwise adjustment
motor. In the event of any obstruction, Turny will
stop and reverse a short distance.
Cable break or limit sensor for rotation motor out of
service.
Cable break or limit sensor for longitudinal adjust-
ment motor out of service.
Cable break or limit sensor for lifting motor out of
service.
Overloading on rotation motor.
1 Check that nothing is obstructing the movement.
2 Drive in the emergency-mode operating position,
then contact the installer.
Remove the obstruction and try again.
Remove the obstruction and try again.
Remove the obstruction and try again.
Drive in the emergency-mode operating position,
then contact the installer.
Drive in the emergency-mode operating position,
then contact the installer.
Drive in the emergency-mode operating position,
then contact the installer.
1 Check that nothing is obstructing the movement.
2 Test without anyone in the chair. Contact the in
staller if the problem remains.
27