Delete User Codes; All Codes Reset - Fermax LOFT Benutzerhandbuch

Delete user codes (AA)
It is possible to delete or cancel a given user code. To do so, proceed as follows:
All codes reset (A9)
This operation lets you delete all the access codes in the system memory.
Allow users to change their own access codes (A5)
It is possible to let the users change the access codes they have been assigned for
another personal code. To do so, you must enable this function:
1º Enter the programming mode:
2º Key in option:
3º Key in the position in the memory
of the access code to delete:
Example: Delete access code saved in
position 00.
NOTES: It will be only possible to delete a code if the associated position is known, which
is why we underline the importance of making a list with the positions of the codes programmed
in the system.
The action of deleting a code is irreversible, so that once deleted it cannot be retrieved.
1º Enter the programming mode:
2º Key in option:
3º Key in the Master Code:
Example:
Reset all existing access codes.
NOTE: Reset is an irreversible operation, so the codes stored previously cannot be
retrieved again.
1º Enter the programming mode:
2º Key in option:
3º Key in "1" to enable permit
Key in "0" to disable it:
Example: Enable users personal access
code change
Código Máster (1480)
AA
00...99
1480 AA 00
Master Code (1480)
A9
Master Code (1480)
1480 A9 1480
Master Code (1480)
A5
1: Enabled
0: Disabled
1480 A5 1
beep (x4)
beep (x4)
beep (x4)
beep (x4)
beep (x4)
beep (x4)
beep (x4)
beep (x4)
beep (x4)
Pag 7