Assembly
1. Insert the handle (1) into the frame legs (13). If insertion is difficult you can use an appropriate tool to gently
tap the handle into place. Secure the handles with a screw on each side.
2. Attach the cross beam (11) to the frame legs (13).
3. Mount the wheels (9) to the undercarriage (10). Fit washers on both sides of each wheel. Make sure that
the bearing sleeve is present in the hub of each wheel. Do not over-tighten the nut. The wheels must be able
to spin freely.
10
4. Place the undercarriage (10) on the floor with the frame legs (13) folded over it.
5. Screw the frame legs to the undercarriage. Do not over-tighten the nuts.
9
4
13
10