Operation; Install The Software - Hach AV9000 Bedienungsanleitung

Figure 8 Avoiding silt when mounting the sensor
1 Water
2 Pipe

Operation

For sensors connected to an FL900 flow logger, connect a computer with
to the flow logger to configure, calibrate and collect data from the sensors. Refer to the
Desktop documentation to configure, calibrate and collect data from the sensor.
For sensors connected to an FL1500 flow logger, refer to the FL1500 flow logger documentation to
configure, calibrate and collect data from the sensors. As an alternative, connect a computer with
DATA Desktop software to the flow logger to configure, calibrate and collect data from the
FS
sensors. Refer to the
the sensor.
For sensors connected to an AS950 sampler, refer to the AS950 sampler documentation to
configure, calibrate and collect data from the sensors.
For sensors connected to a Sigma 910, 911, 920, 930 or 940 flow meter, connect a computer with
InSight software to the Sigma flow meter to configure, calibrate and collect data from the sensors.

Install the software

Make sure that the latest version of the
the computer as applicable. Download the software from http://www.hachflow.com. Click Support,
then select Software Downloads.
Configure the sensor
For sensors connected to an FL900 flow logger, configure the sensors with the
Setup Wizard. Refer to the
14 English
DATA Desktop documentation to configure, calibrate and collect data from
FS
DATA Desktop software or InSight software is installed on
FS
DATA Desktop documentation for instructions.
FS
3 Sensor
4 Silt
DATA Desktop software
FS
DATA
FS
DATA Desktop
FS