Ironing Tips; Vertical Steam Ironing; Refilling The Water Tank; Safety / 3 Way - Auto -Off Function - Fakir VIVALDI Benutzerhandbuch

6. To generate steam, press the steam trigger and hold down for a steady flow of steam.
Once you release the trigger, steam will stop.
7. For a continuous flow of steam, push the steam control button forward to the unlock
position. To stop steam flow, switch the steam control button back to the lock position.
8. Turn the steam control dial clockwise to increase steam level and counter clockwise
to reduce steam.

IRONING TIPS

• Start with the fabrics to be ironed at a low temperature and finish with those which
need higher temperatures.
• For mixed fibre fabric, set the ironing temperature to a lower setting.
• For woollen garments, press the steam trigger repeatedly over the garment without
physically touching it with the iron.
• For thicker fabrics, raise the steam output by turning the steam control dial to the right.
• For low temperature setting on the dial, reduce the steam level by turning the steam
control dial to the left.

VERTICAL STEAM IRONING

This feature allows you to smooth out creases in garments, manchester or drapery in
a similar manner to a garment steamer. The high steam pressure of the Steam Station
can provide bursts of steam while holding the iron vertically. For best results, utilise
on delicate or light fabrics. To produce the maximum amount of steam, set the steam
setting to MAX. Only direct steam at hanging garments in a safe area and ensure you
always refer to garment manufacturer recommendations.
WARNING!
Do NOT direct the steam onto a garment that is being worn or at any person.

REFILLING THE WATER TANK

When running low on water, the Steam Station will stop emitting steam even if you press
the steam trigger, and the low water indicator light will flash red. Yo do not have to switch
off the Steam Station to refill the water tank. Simply remove the water tank to refill, or
use a cup or bottle to pour water into the easy-fill water tank inlet.

SAFETY / 3 WAY - AUTO -OFF FUNCTION

VIVALDI Steam Station Iron has electronic safety Auto-off function which will turn the
iron off after it is placed on the soleplate for more than 30 seconds and If it is knocked
onto its side. If the Iron is in vertical position or on the station, this will happen after
8 minutes. After the iron is shut off, if need to use the iron again, need to repress the
power switch to restart the power.
21
EN