Laserscale BL55-003NE-Serie Anbringungsanleitung Seite 17

Operating Precautions
• An antistatic cap is attached to the connector plug of
the interface unit. Do not remove this cap until you
are ready to connect the peripherals.
After removing the static electricity proof cap, take
care not to touch the connector pins as this might
cause malfunctions.
• Be sure to make all connections of the interface unit
connector and the peripherals before switching the
power on.
Never insert or pull out the connector when the power
switch is on.
• Do not pull at the cable forcibly or bend it excessively.
(Bending radius (inside) Static: 30 mm or more,
Moving: 100 mm or more)
• Use the BL55-NE approximately 10 minutes after
power is supplied to the unit, when the temperature
of the detector head reaches a stable state.
• The BL55-NE is a precision measuring instrument.
Handle it with extreme care so that no excessive
shock is applied to it. For transport, be sure to pack
it in the same way as it was packed at the time of
purchase. Be sure to always attach the antistatic
cap to the connector.
Notes on installation
Take careful note of the following points when installing
the scale unit to prevent noise and electromagnetic in-
terference from other equipment.
• Do not pass the head cable and connection cable
through the same duct as the power line.
• Install in a location that is at least 0.5 meters sepa-
rated from sources of high voltage and large cur-
rents and large power relays.
BL55-NE
Notes on attachment location
• Attach the scale in a location as near as possible to
the workpiece and measurement object of the ma-
chine.
• Use this product in an environment with an ambient
temperature of 0 to 40 °C.
Do not attach it to a location that is exposed to direct
sunlight or warm air or near sources of heat such as
motors. This could adversely affect the accuracy.
• If using a water-soluble cutting fluid or other sub-
stances, ensure that there is adequate protection so
that it does not adhere to the scale.
• Never place objects on top of the attached scale, rest
your elbows or feet on the scale when using it, or
apply an excessive amount of pressure to the scale.
Notes on storage
• Do not store in locations with high temperatures or
high humidity.
This could have an adverse effect on scale perform-
ance. Store in a location that is as dry as possible.
General Precautions
When using Magnescale Co., Ltd. products, observe
the following general precautions along with those given
specifically in this manual to ensure proper use of the
products.
• Before and during operations, be sure to check that
our products function properly.
• Provide adequate safety measures to prevent dam-
ages in case our products should develop malfunc-
tions.
• Use outside indicated specifications or purposes and
modification of our products will void any warranty of
the functions and performance as specified of our
products.
• When using our products in combination with other
equipment, the functions and performance as noted
in this manual may not be attained, depending upon
operating environmental conditions. Make full study
of the compatibility in advance.
(3)
(E)