Maintenance - Nordmende SOP500IX Montage- Und Bedienungsanleitung

PART 5: CLEANING AND MAINTENANCE OF YOUR OVEN
5.1. CLEANING
Before starting to clean your oven, be sure that all control buttons are off and your appliance
is cooled off. Unplug the appliance.
Do not use cleaning materials containing particles that might scratch the enamelled and
painted parts of your oven. Use cream cleaners or liquid cleaners, which do not contain
particles. As they might ahrm the surfaces, do not use caustic creams, abrasive cleaning
powders, rough wire wool or hard tools. In the event the excess liquids spilling over your
oven should burn, it may cause a damage to the enamel. Immediately clean up the split
liquids. Do not use steam cleaners for cleaning the oven.
Cleaning the interior of the oven
Make sure to unplug the oven before starting to clean it. You will obtain best results if you
clean the oven interior while the oven is slightly warm. Wipe your oven with a soft piece of
cloth dampened with soap water after each use. Then wipe it again, this time with a wetted
cloth, and wipe it dry. A complete cleaning using dry and powder type cleaners. For product
with catalytic enamel frames, the rear and side walls of the inner frame do not require
cleaning. However; depending on usage, it is recommended that you replace them after a
certain period of time.
* The door seal may be cleaned using a sponge that has been soaked in lukewarm water.
Do not use abrasive cleaners and do not crumble the seal.
* Check the door seals around the oven periodically. If the seals are damaged, please
contact your nearest Technical Service Center and make change it with new one.

5.2. MAINTENANCE

Replacing the Oven Light
It is recommended that you leave this operation to the Authorized Service. Unplug the oven
first and make sure that is cold. After removing the lid in front of the light, take also the bulb of
its place. Insert the new bulb resistant to 300ºC, which you will find at Authorized Services,
into the place of the bulb you have removed. Then fit the light protecting glass back into its
place. After that, your oven will be ready for use.
21