Installation - Lehmannaudio Linear Bedienungsanleitung

42 Linear

Installation

EN
In this chapter you'll learn more about the connections,
controls and possible applications of your Lehmannaudio Linear
headphone amplifier.
1 | Unpacking
After unpacking the Linear check it for possible transport damages. If you notice
visible damages, you must by no means connect the device to mains. In this case
consult your dealer immediately.
The delivery comprises the following components:
Linear unit
≠
Power cord
≠
User manual
≠
Guarantee voucher
≠
Note
We recommend keeping the entire packaging for later shipment.
That way you will avoid transport damages. Use by no means
'foam chips' or similar packaging material. Otherwise the device
will jolt through to the bottom of the cardboard box during
transport and can be damaged! If the original packaging is no
longer available, it's best to use bubble wrap in which to wrap up
the device in a generous manner. Finally the whole should be put
into a solid cardboard box.
2 | Placement
Always put the Linear on a solid base. Alternatively the device may also be
mounted under a table using the optional accessory kit. Due to its compact
dimensions and low weight you can take the Linear easily with you.
3 | Wiring
First check the present mains voltage since the Linear can only be operated on
the mains voltage which the unit has been designed for. This can be read on a
sticker on the bottom side of the device. Now connect the Linear to the mains
grid using the power cord and the mains inlet located on the rear side of the
unit.
Observe the safety notes from page 34!
Linear 43
EN