Setting Into Operation; Rack Installation; Connecting Audio Devices; Establishing The Data Connection - Omnitronic DXO-26S Bedienungsanleitung

Digitale frequenzweiche

Inhaltsverzeichnis

Verfügbare Sprachen

5. SETTING INTO OPERATION

Install the unit on a plane surface or fasten it to the wall via the cutouts in the housing.

Disconnect the DXO-26S from the mains and switch off the units to be connected before making or

changing the connections.

1. The XLR inputs and outputs can be connected both balanced and unbalanced ( s. 7.1 Occupation XLR

connection). Balanced cables provide +6 dB more output and guarantee a better protection against

interference in case of long cable runs.

2. Connect the signal source (e.g. preamplifier, mixer) to the input jacks INPUT A and B.

3. Connect the PA amplifiers to the output jacks OUTPUT 1 to 4.

4. Connect the power supply unit to the power input jack and the mains plug to a mains outlet. Thus the

unit is powered on and is in standby mode. By disconnecting the unit from the mains it can be switched

off.

The power cable can be secured to the unit via the strain relief.

Always disconnect the mains connector when you wish to change connections, move the unit to a

different place or if it is not used for a longer period.

Caution! Use only the supplied power unit otherwise the unit will be damaged.

1. For controlling the crossover a special PC software on CD-ROM is included. Install the software on your

computer and connect the USB port to your computer via the supplied USB connection cable. The

crossover is compatible with PC computers. A matching driver for the connection via the USB interface is

automatically installed together with the software. As soon as the unit is connected to a computer, the

USB interface will be recognized and is ready for operation.

2. After connecting, start the PC software. If the program has already been started prior to the connection,

it must be terminated and restarted, otherwise the crossover is not found.

If needed an external control unit can be connected to control the crossover. For this connect the screw

terminals REMOTE to the output of the control unit.

14/15

00054084.DOC, Version 1.0

Inhaltsverzeichnis