Quax INDIGO Bauanleitung Seite 35

INDIGO
540454xx-2D
4. Assembling the wardrobe
Step 1 : Use both long crossbars ES3, both short crossbars ES2, eight eccentrics A, the four legs ES1,
eight connectors B, sixteen wooden dowels C and four leg sliders D
Push two eccentrics (A) in the drillings on the inside of the crossbars (ES2 and ES3). Tighten two wooden
dowels (C) in the holes on the ends of the crossbars. Fasten two connectors (B) in the drillings on the in-
side of the legs (ES1). Push the leg sliders (D) in the drillings at the bottom of the legs. See further below.
Step 2 : Use the parts of step 1
Push the legs (ES1) with their connectors into the holes and over the wooden dowels of short crossbars
(ES2). Tighten the eccentrics. Push the long crossbars (ES3) with their wooden dowels into the holes and
over the connectors of a leg frame. Tighten the eccentrics. Push the other leg frame with its connectors in
the drillings and on the wooden dowels of the long crossbars. Tighten the eccentrics.
Kleerkast met twee draaideuren
Schrankwand mit zwei Türen
Armoire avec 2 portes battantes
Wardrobe with two doors
Quax Quax
First dreams First dreams
® ®
First steps First steps
35