Replacing The Dustbag; Motor Protection Filter - Philips Jewel Serie Bedienungsanleitung

3 You can put the appliance in upright position and attach the nozzle to the appliance by
inserting the ridge on the nozzle into the slot (fig. 25).
4 Always put the Tri-Active nozzle in the carpet setting when you store it and prevent the side
brushes from becoming bent (fig. 9).

Replacing the dustbag

Always unplug the appliance before replacing the dustbag.
Replace the dustbag as soon as the dustbag-full indicator has changed colour permanently, i.e.
even when the nozzle is not placed on the floor (fig. 26).
1 Open the cover by pulling it upwards (fig. 27).
2 Lift the dustbag holder out of the appliance (fig. 28).
Make sure you hold the dustbag upright when lifting it out of the appliance.
3 Remove the full dustbag from the holder by pulling at the cardboard tag (fig. 29).
When you do this, the dustbag will be sealed automatically.
4 Slide the cardboard front of the new dustbag into the two grooves of the dustbag holder as
far as possible (fig. 30).
5 Re-insert the dustbag holder into the vacuum cleaner (fig. 31).
You cannot close the cover if no dustbag has been inserted.
Cleaning and maintenance of filters
Always unplug the appliance before replacing the filters.

Motor Protection Filter

Clean the Permanent Motor Protection Filter every time you replace the dustbag.
1 Remove the dustbag holder with the dustbag (fig. 28).
2 Take the Motor Protection Filter holder out of the appliance and clean the filter by shaking it
over a dustbin (fig. 32).
3 Put the clean filter back into the filter holder. Fit the two lugs of the filter holder behind the
ridge at the bottom to ensure that it fits properly at the top and press the filter holder home
('click') (fig. 33).
4 Place the dustbag holder with the dustbag back into the appliance.
Super Clean Air Filter
The Super Clean Air Filter located in the back of the appliance filters a large part of the smaller
particles from the exhaust air by means of its electrostatically charged fibres.
Replace the Super Clean Air Filter every six months.
1 Open the filter grille (fig. 34).
2 Remove the old filter (fig. 35).
3 Insert the new filter into the appliance.
4 Close the filter grille and push the bottom corners until they snap home (fig. 36).
ENGLISH
9