Installation; Mounting - True Systems P2 Analog Bedienungsanleitung

Starting up

inStAllAtiOn

Mounting

Ventilation
24
analog
P2
Unpacking and Inspection
We recommend that you inspect your P2
from the factory shipping carton. In the unlikely event that the unit ex-
hibits any physical damage, DO NOT connect it to the AC mains power,
but contact your dealer immediately.
analog
In addition to the P2
• AC power cord
• Operation Manual
• Warranty registration sheet
We recommend that you keep the shipping carton and foam supports in
the event that the unit must be shipped at some time in the future. DO
NOT package the unit in "packing peanuts" or similar material as it will
settle during shipping and damage will likely occur. If original packing
materials cannot be located, wrap the unit with a liberal amount of plastic
"bubble wrap" material extending at least 2" beyond the extremities of
analog
the P2
enclosure.
analog
The P2
is designed for conventional rack mounting, or stand-
alone mounting by use of the adhesive rubber feet supplied. Avoid locat-
ing the unit next to equipment that emits strong electromagnetic fields. If
the unit is to be permanently mounted in a high vibration environment,
you may wish to provide additional side or rear support to prevent pos-
sible distortion of the mounting ears.
• Do not locate the unit where it is exposed to rain, moisture, or liquid
spills.
• Do not locate the unit where it is exposed to temperature extremes.
We recommend that you provide adequate ventilation so that the air
temperature surrounding the unit does not exceed °C (122°F). If mul-
tiple units are to be mounted in a poorly ventilated rack or travel case, a
1 /4" blank space should be located after every three units (three units
mounted together, blank space, three more units, etc.).
PRECISION 8i
systems
TRUE
analog
, the shipping carton should also include:
PSU-P8i
upon unpacking it