Blaupunkt HCC401 Bedienungsanleitung Seite 6

HCC401
1. Lenght adjustment cup
2. Blades
3. On/off button
4. Slide button for distance setting
5. Machine oil for blades
CHARGING THE APPLIANCE
If the appliance's battery charge is low or the battery is totally discharged, it needs charging. Insert the
power supply cord into the appliance and connect the power supply unit to the electrical grid.
The charging indicator of the appliance will then display its charging status. If the appliance is totally
discharged, the indication of its charging status may be delayed. This delay should be no longer than 2
minutes.
Having connected the appliance to the charger, you may continue using the appliance. However, do
not use the appliance in the vicinity of baths, showers, swimming pools or similar water tanks.
HAIR CLIPPER OPERATION
The slide button regulates the comb length between 3-24mm.
Switch the shaver on with the On/Off button. Slowly move the appliance over the hair. It is
recommended to shave "against the grain", against the direction of the hair growth.
Note: Make sure you remove any excess cut hair from the limit comb.
Having finished clipping, remove all hair from the trimming head.
HAIR CLIPPER CLEANING
Prior to cleaning the appliance, ensure that it is switched off and not being charged.
Clean the limit combs under running water.
Sweep the blades with the brush. Remove the trimming head by pressing down gently on the blades,
as shown in figure 3. The trimming head may be cleaned under running water. Remove impurities with
a brush from the inside of the appliance.
It is recommended that a little machine oil is applied onto the cleaned blades.
6. Charging socket
7. Cleaning brush
8. Comb
9. Adaptor
4