Cleaning And Maintenance; Danger To Life; Replacing The Fuse - EuroLite LCD-4/S Bedienungsanleitung

The steps cannot be edited or deleted. You must program new steps, starting from step 1.
Function: call up the programs
You have different possibilities to call up the program.
Press and hold the buttons PROG SELECT and Stand By until the display shows"St". This means that you
can call the steps manually by pressing the PROG SELECT button.
Press and hold the buttons PROG SELECT and Stand By until the display shows"ASt". This means that the
steps are called sound-controlled. Make sure that the Audio-control is set to 100 %.
Press and hold the buttons PROG SELECT and Stand By until the display shows"AP". This means that the
steps are called with the speed adjusted via the Speed-control.
You can adjust the Fade Time with the FADE TIME-control. Dimmer is no longer activated.

7. CLEANING AND MAINTENANCE

We recommend a frequent cleaning of the device. Please use a soft lint-free and moistened cloth. Never use
alcohol or solvents!
There are no servicable parts inside the device except for the fuse. Maintenance and service operations are
only to be carried out by authorized dealers.

7.1 Replacing the fuse

If the fine-wire fuse of the device fuses, only replace the fuse by a fuse of same type and rating.
Before replacing the fuse, unplug mains lead.
Procedure:
Step 1: Unscrew the fuseholder with a fitting screwdriver from the housing (anti-clockwise).
Step 2: Remove the old fuse from the fuseholder.
Step 3: Install the new fuse in the fuseholder.
Step 4: Replace the fuseholder in the housing and fix it.
Should you need any spare parts, please use genuine parts.
If the power supply cable of this device becomes damaged, it has to be replaced by authorized dealers only
in order to avoid hazards.
Should you have further questions, please contact your dealer.

DANGER TO LIFE!

Disconnect from mains before starting maintenance operation!
18/33 70062661_V_2_1.DOC