Connection With The Mains; Outputs; Operation; Hold-Dimmer Mode - EuroLite LCD-4/S Bedienungsanleitung

Connect the sound-signal from the mixer (e.g. Master 2) with the RCA-socket on the rear panel (input
sensitivity 0.1 V - 1 V).

5.3 Connection with the mains

Connect the device to the mains with the power-plug.
The occupation of the connection-cables is as follows:
Cable Pin
Brown Live
Blue Neutral
Yellow/Green Earth
The earth has to be connected!
If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.

5.4 Outputs

Output is via 4 safety sockets on the rearpanel.
Connect your loads via the output-sockets. The maximum load per channel is 1,150 W. Please note that the
maximum current of 16 A must never be exceeded.

6. OPERATION

After you connected the device to the mains, the LCD-4/S is ready for use.
Please note: when you hold the Prog Select-button and press the Mode Select-button, you can invert the
selection of the programs.

6.1 Hold-Dimmer Mode

Call spots manually:
In the Hold Dimmer Mode, the connected spots can be called manually and be controlled via the channel
faders.
Adjust the desired function via the channel faders.
1. Turn controller ON
2. Press Mode Select until Hold Dimmer LED is illuminated
3. Adjust channel faders
4. Adjust dimmer fader for total output
This function is useful for theatres and booth illumination.

6.2 Hold-Sound Mode

Spots as light organ:
In this mode, the LCD-4/S works as light organ. Every channel is assigned to a special frequency. The spots
reacts in accordance to the music level. Additionally, the Flash-buttons can be used..
1. Turn controller ON
2. Press Mode Select until Hold Sound LED is illuminated
3. Adjust dimmer fader for total output
4. Adjust Audio fader until the spots react to the sound signal
International
L
N
16/33 70062661_V_2_1.DOC