Overview; Setup; Installation; Sound-Control - EuroLite LCD-4/S Bedienungsanleitung

4.2 Overview

Overview on the control elements
1 2
CH 1
OFF
ON
FLASH
1) POWER SWITCH
2) KANAL-LEDs
3) CHANNEL FADERS
4) FLASH-BUTTONS
5) MODE LEDs
6) MODE SELECT-BUTTON
7) PROG SELECT-BUTTON
8) DISPLAY
9) FADE TIME-FADER
10) DIMMER
11) AUDIO-FADER
12) SPEED-FADER
13) STANDBY-BUTTON
14) FULL ON-BUTTON
15) TAP SYNC-BUTTON

5. SETUP

5.1 Installation

Install the device on a plane surface or install it in rack.
Rack-installation: This device is built for 19" racks (483 mm). The rack you use should be a Double-Door-
Rack where you can open the frontpanel and the rear panel. The rack should be provided with a cooling fan.
When mounting the controller into the rack, please make sure that there is enough space around the device
so that the heated air can be passed on. Steady overheating will damage your device.
You can fix the controller with four screws M6 in the rack.

5.2 Sound-control

The sound-control works via the built-in microphone or via the sound input socket.
For selecting the signal source:
When turning the unit on, press and hold the Prog Select-button and switch between E and I via the Mode-
Select-button.
3 4 5
CH 2 CH 3 CH 4
FLASH FLASH FLASH
6 7 8 9
LCD 4/S
FADE TIME DIMMER
HOLD DIMMER
10 s
HOLD SOUND
PROG. SOUND
I = Internal Mic
E = Audio Line Input
PROG. SPEED
AUTO SPEED/
AUTO SOUND
PROGRAM
STOP
MEMORY
MODE
PROG.
STANDBY
SELECT SELECT
15/33
10 11 12
AUDIO SPEED
MIC
FULL ON FULL ON
13 14 15
70062661_V_2_1.DOC