AFRISO FT Betriebsanleitung Seite 26

5 Mounting
 If you intend to mount multiple products, start by creating a mounting plan
with the appropriate mounting locations. Then label the products with
numbers or the corresponding mounting location to help avoid confusion
of mounting locations.
5.1 Preparing mounting
 Prior to mounting, verify that the solar-operated energy storage module
has been charged.
- Regular daylight is sufficient for charging the energy storage module.
- Exposure to direct sunlight reduces the charging time.
5.2 Mounting the product
 Verify that the mounting position of the product conforms to the mounting
plan.
1. Choose an installation site without direct exposure to sunlight.
- Direct sunlight causes incorrect temperature values.
2. If the product is used in darker environments, install a lithium battery type
½ AA.
5.2.1 Connecting the probe
1. Connect the probe to the product (see chapter "Application exam-
ple(s)").
5.2.2 Mounting the bracket holder
If required, you can use the enclosed holder. Fixate the holder using the
enclosed adhesive dots.
Mounting
1. Mount the holder to a wall or to a
pipe.
Teach in the product before plug-
ging it onto the holder.
2. Push the product onto the holder
until it snaps in.
EN
10
FTM