For Customers In The United States; For Customers In Europe - Sony SS-AR1 Bedienungsanleitung

English

For customers in the United States

Owner's Record
The model and serial numbers are located on the rear of the unit. Record
these numbers in the space provided below. Refer to them whenever
you call upon your Sony dealer regarding this product.
Model No.

For customers in Europe

Notice for customers:
the following information is only applicable to
equipment sold in countries applying EU directives.
This product has been manufactured by or on behalf of Sony
Corporation, 1-7-1 Konan Minato-ku Tokyo, 108-0075 Japan. Inquiries
related to product compliance based on European Union legislation
shall be addressed to the authorized representative, Sony Deutschland
GmbH, Hedelfinger Strasse 61, 70327 Stuttgart, Germany. For any
service or guarantee matters, please refer to the addresses provided in
the separate service or guarantee documents.
Speaker unit (Tweeter)
Speaker unit (Midrange)
Speaker unit (Woofer)
Baffle board
Check that the amplifier/
speaker cables meet
specifications
Select an amplifier (not supplied) and speaker cables (not supplied) meeting the
following requirements.
Requirement for selecting an amplifier
The amplifier should be capable of driving 4 ohm loads. Excessive volume may
damage the speakers; therefore, set the volume level low to avoid excessive input
to the speakers.
Serial No.
Disposal of Old Electrical & Electronic
Equipment (Applicable in the European Union
and other European countries with separate
collection systems)
This symbol on the product or on its packaging indicates
that this product shall not be treated as household waste. Instead it shall
be handed over to the applicable collection point for the recycling of
electrical and electronic equipment. By ensuring this product is
disposed of correctly, you will help prevent potential negative
consequences for the environment and human health, which could
otherwise be caused by inappropriate waste handling of this product.
The recycling of materials will help to conserve natural resources. For
more detailed information about recycling of this product, please
contact your local Civic Office, your household waste disposal service or
the shop where you purchased the product.
Duct
Enclosure
Duct
Terminals
Spikes
Requirement for selecting speaker cables (one pair)
In order to output high quality sound signals, prepare a pair of speaker cables of
the required length. Use speaker cables that are terminated with either one of the
following two options.
 With cable core (less than 4 mm (5/32 in) in diameter) bared by stripping 10 mm
(13/32 in) of sleeve off the ends of each cable
The bare cable core may become oxidized over time. In that case, reconnect
the speaker cables after stripping the sleeve to expose a fresh segment of cable
core at each end. This will ensure you can enjoy better sound.
 With spade plugs (more than 6 mm (1/4 in) in inside diameter, and less than
12 mm (1/2 in) in outside diameter)