Product Warranty - Redmond RI-C222-E Bedienungsanleitung

IV. BEFORE CONTACTING SERVICE CENTRE
Problem Possible cause
The power cord is not connected to
an electrical outlet
Soleplate remains cold, Electrical outlet is not working prop-
heating indicator does erly
not light up
Auto shut-off feature activated (auto
shut-off indicator on the handle is
flashing)
Soleplate barely warms
Selected temperature is too low
up
Iron produces no steam Steam feature is disabled
Not enough water in the water tank Fill the water tank at least ¼ full
The steam output control dial is set
Iron produces very lit-
to medium setting
tle steam
Anti-drip feature activated
You used water with chemical addi-
tives
Steam coming from the
You used distilled or softened water
holes in soleplate
stains fabric
You did not empty the water tank
after last use
Selected temperature is too high
Soleplate is dirty and
stains the fabric
Fabric has not been rinsed suffi-
ciently or you have ironed new gar-
ment before washing it
Selected temperature is too low
Water drips from holes
The soleplate temperature is too low
in soleplate
because you are using the Steam Shot
feature too often
Solution
Connect to an electrical outlet
Soleplate is damaged
Connect to properly functioning
electrical outlet
Refer to section "Auto shut-off fea- V. PRODUCT WARRANTY
ture"
We warrant this product to be free from defects for a period of 2 years from the date of purchase.
Turn the temperature control dial to
If the appliance fails to operate properly within the warranty period and is found to be defective
select required temperature
in material or workmanship, we will repair or replace it free of charge. This warranty comes into
force only in case an original warranty service coupon with a serial article number and an accurate
Turn the steam output control dial
impress of the company of the seller proves the purchase date. This limited warranty does not
to select required steam output
cover damage caused by the failure to use this product for its normal purpose or in accordance
with the instructions on the proper use and maintenance of the product, or any kind of repair
Turn the steam output control dial works. Do not try to disassemble the appliance and keep all package contents. This warranty does
not cover normal wear of the appliance and its parts (filters, bulbs, non-stick coating, gaskets, etc.).
to increase steam output
Wait for the soleplate to reach the Service life and the applicable product warranty period start on the date of purchase or the
selected temperature (heating indi- date of manufacture (if the purchase date cannot be established).
cator goes out)
You can determine manufacture date by serial number, located on the identification label
Do not use water with chemical ad- on the housing of the appliance. The serial number consists of 13 digits. 6th and 7th digits
ditives
of the serial number identify the month, 8th digit the year of manufacture.
Use common tap water or half tap Service life of the product, established by the manufacturer is 3 years from the date of
purchase, provided that the appliance is used and maintained in accordance with the user
water and half distilled water
manual and applicable technical standards.
Carry out the self-cleaning procedure.
Always empty the water tank after use
Refer to "Fabric Ironing Chart" and
garment labels to select the correct
temperature
Clean the soleplate. Thoroughly
rinse the garment to remove any
traces of detergent residue that may
With this little extra effort, you can help to ensure that valuable raw materials are recycled and
damage the soleplate
pollutants are treated as appropriate.
Turn the temperature control dial
This appliance is labelled in accordance with European Directive 2012/19/EU – concerning used
into • •, • • •, or "Max" position
electrical and electronic appliances (waste electrical and electronic equipment WEEE).
The guideline determines the framework for the return and recycling of used appliances as ap-
Increase intervals between steam
plicable throughout the EU.
shots
Problem Possible cause
You placed the iron down flat on a
metal surface
The soleplate was damaged by a gar-
ment accessory (zip fastener, button,
rivet, etc.)
Environmentally friendly disposal (WEEE)
The packaging, user manual and the device itself shall be taken to the appli-
cable collection point for the recycling of electrical and electronic equipment.
Do not throw away the electronic waste to help protect the environment.
Old appliances must not be disposed with other household waste but must be
collected separately. Municipal disposal of recyclable wastes is free of charge.
The owners of old appliances are required to bring it to a waste facility centre.
RI-C222-E GBR
Solution
Use special iron support. Always
store the iron in vertical position
Avoid placing the iron on sharp
objects, such as zip fasteners, but-
tons, or rivets during ironing to
prevent damage to soleplate
7