Cleaning And Storage; Specification - h.koenig MXK30 Bedienungsanleitung

glass jar at the same time. And the ratio of quantity of carrot and water is2:3. That is
to say, if you want to blend the maximal capacity of mixture of carrots and water, the
carrots are not more than 600g, and the water is about 900g (0.9L).
- If you are blending solid ingredients, cut them first into small portions (1.5-2cm).
- When blending solid ingredients, start by adding a small quantity of liquid.
Gradually add further quantities of liquid through the lid opening.
- Always hold the blender top steady with your hand while the appliance is operating.
- Proceed carefully when blending thick liquids.
- To blend solid ingredients or very thick liquids we recommend you use the "Pulse"
setting to prevent the blades from sticking.
- If you want to crush ice, the quantity of ice in glass jar is not more than 12pcs, and
size of the ice is not more than 20*20*20mm.
CAUTION
If the glass jar is filled too much ingredient, the blades may not spin freely thus
preventing the blending cycles from operating correctly. If this happens, switch off the
unit and unplug from the socket. Empty some of the contents and then switch on
again.

CLEANING AND STORAGE

Warning: Switch off the unit and then unplug the power cord before cleaning to prevent electric
shocks and other hazards.
1. In addition to this, you should read the "Safety precautions" section at the beginning of
these instructions.
2. Do not clean the motor housing, the power cord or the plug with water.
3. Clean the motor housing with a soft, damp cloth and wash with a mild detergent.
4. Half-fill the glass jar with hot water and a small amount of washing liquid. Leave the unit to
operate at maximum speed until the glass jar is clean (maximum 1 minute).
5. You know the jar base can be separated from the glass jar, you can turn the jar base in a
counter-clockwise direction and remove the blade assembly together with the rubber seal.
Then you can clean the blade base and rubber seal with a soft, damp cloth or wash with
mild detergent. CAUTION: The blades are very sharp. Care must be taken when
cleaning.
6. Clean the grinder by half-filling the grinder glass container with hot water and a little
washing liquid; fix the grinder on to the top of the motor base. Leave the unit to operate at
maximum speed until cleaned (Maximum 30 seconds). Then use the water to clean all
grinder components.
7. Dry all components well before using again.
8. Never use abrasive detergents.
 Never use aggressive cleaning agents.
Warning:
Do not to touch the sharp blade. When clean, please wipe by dishcloth, to
avoid accidentally injure.
Rated voltage ；220-240V,50/60Hz
：
Power
Capacity ：
： 1 minute
Operating time

SPECIFICATION

700W
1.5L