Configuration Mode - M-Life ML0585-5 Bedienungsanleitung

1.2. Computer configuration via Wi-Fi
1. Click Start → Control Panel → Network and Internet → Network and Sharing
Center → Change adapter settings → Wi-Fi (right click) → Properties.
2. Double click Internet Protocol Version 4 (TCP/IPv4).
3. To set up the computer IP 192.168.10.x (x arbitrary integer between 2~252),
subnet mask of 255.255.255.0, gate of 192.168.10.1 and click OK. Back to the
last interface and click OK.
4. Plug the Wi-Fi Repeater to a wall socket.
5. Click on the network icon
the signal from the Wi-Fi Repeater. Click on Connect and wait few seconds.
6. Connect to a Network will appear on the screen.
NOTE! When configuring via Wi-Fi, enter all required advanced settings (e.g. broadcasted
network security) before launching selected configuration mode. After launching selected
mode (e.g. repeater), it would be possible to access settings only when configuring via
LAN cable (see point 1.1).
2. Connection
1. Open web browser and type http://192.168.10.1 in the browser's address box. This
number is the default IP address for this device.
NOTE! If you cannot load http://192.168.10.1, please check whether Wi-Fi repeater is on
default settings. If not, or if you cannot verify the reason for lack of connection, restore
default settings. Press the reset button for about 10 seconds and try to install it again.
2. The login screen will appear. Enter the Username and Password then click Login to
login. The default Username is admin, default password is admin.
3. After logging in, you will see 5 modes: Router Mode, AP Mode, Repeater Mode,
WISP Mode and Client Mode.
EN

3. Configuration Mode

1. Configure Router Mode
10
Owner's manual
on the right bottom of your desktop. You will find