Installation Of The Indicator; Repairs; Cleaning And Lubrication - DIEBOLD HSK-100 Bedienungsanleitung

Messtechnik
7.

Installation of the Indicator

Disassembling:
Using the thumb-wheel, release the indicator clamp and remove the indicator from the unit.
Unscrew the probe and install the probe in replacement indicator.
Installation:
Install the new indicator in the bore, move the indicator forward till the dial indicator moves
to midpoint of travel. Tighten the indicator clamp and set indicator to "0" by turning the
housing.
Attention:
Avoid binding the indicator cylinder by over-tightening the clamp.
8

Repairs

Diebold PullForce Gauges are a modular system. When a component is damaged, only
the damaged component needs to be replaced. We recommend returning any damaged
gauge to the manufacturer, Helmut Diebold GmbH & Co. or a certified service station for
recalibration and certification. Periodic
recommended.
9

Cleaning and Lubrication

Clean the unit with a clean cloth and oil.
G:\Bedienungsanleitungen\Messtechnik\Spannkraftprüfer\Bedienungsanleitung
Spannkraftprüfer D+E.dot
recalibration of gauge master is also
上海川奇机电设备有限公司
Stand: März 2010 Seite 15 von 16