Preparation Of The Pullforce Gauge; Pullforce Check; Minimum Suggested Drawbar Pullforce - DIEBOLD HSK-100 Bedienungsanleitung

Messtechnik
3

Preparation of the PullForce Gauge

How to adjust the PullForce Gauge
5. Install the Pull Stud in the thread of the taper (SK/ANSI/BT Versions)
6. Clean the spindle taper
7. Clean the taper of the PullForce Gauge
8. Set Indicator to ,,0" position (see 2.1)
4

PullForce Check

Hold the PullForce Gauge in the taper of the machine and activate the clamping system of
the spindle. The indicator will show the pull force in kN (kiloNewton). For minimum
suggested pull forces see the following table 5.0.
5

Minimum suggested Drawbar Pullforce

Minimum Pull Force
Of taper size
Taper Size HSK25
Taper Size HSK-32
Taper Size HSK-40
Taper Size HSK-50
Taper Size HSK-63
Taper Size HSK-80
Taper Size HSK-100
Taper Size SK-30
Taper Size SK-40
Taper Size SK-50
More detailed values you'll get from the manufacturer of the spindle..
G:\Bedienungsanleitungen\Messtechnik\Spannkraftprüfer\Bedienungsanleitung
Spannkraftprüfer D+E.dot
2,8 kN
5,0 kN
6,8 kN
11,0 kN
18,0 kN
28,0 kN
45,0 kN
6,0 kN
12,0 kN
25,0 kN
Stand: März 2010 Seite 13 von 16