Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
To
set
the
correct
time on the Clock Display, use the following
procedure:
1 Connect the
AC Power Cord to your household AC
power outlet.
-The
Clock Display
will begin to flash
continuously
.
2.
Set the Brightness¡Time
Set Selector to
"ITIME SETI"
.
3.
Press and hold the Time
Set Buttons
until the correct
time
appears on
the
Clock
Display.
-
The
digits should stop
flashing
.
-
The FWD Button
forwards Ihe displayed time and the REV Button
reverses
it.
-To forward
or
reverse the displayed time
rapidly,
press
and hold
the
FAST
Button
with
the FWD
or
REV
Button.
-To forward
or
reverse the displayed time minute
by
minute, press
the
FWD
or REV
Button
repeatedly.
-For
U.K., observe the
PM Indicator.
A green
dot
indicates
"
PM
"
and
no
dot
indicates "AMO,
-The
seconds
are automatically
set to
" O"
when the
FWD
or
RE
V
Button is
pressed.
4.
Reset the BrightnessfTime Set
Selector to
"
HIGH
"
or
"LOW"
.
-To increase the brightness of the time
display,
set
this
Selecto
r
to
"
HIGH"; to decrease it, set to
"LOW"
.
•
Antennas
FM;
To
obtain the
best FM reception
,
extend
the FM Antenna
Cord
fully.
1. Press the Radio On
Button.
-The
Radio On Indicator will
light
up.
2.
Set the Band Selector to
the
desired
radio
band
o
3. Tune in the
desi
red
station
with the Tuning Control.
4. Adjust the
Volume and
Balance
Controls
to
the desired
levels.
5. Set the Ambience
Switch and
the
Booster
Switch to
the desired positions
(Refer
below)
.
6. To turn the radi
o
off,
press the
Off
Button.
Notes:
-To receive FM
stereo
broadcasts,
set
the Band Selector to
"FM ST".
The FM
Stereo Indicator
will light during stereo broadcasts.
-If
FM
stereo
reception is poor (excessive
noise, FM Stereo Indicator
flickers)
,
set
the Band Selector
to
"FM"
This will reduce the
noise
and provide
clear reception
;
however,
the
broadcast
will
not
be heard
in stereo
.
• Ambience Switch
When
this
switch
is
set
to
"
ON"
,
the
ambience
sound system
enhances
the
sound from a normal stereo
sound
source.
Ambien
ce
mode increases
the
stereo
imaging
,
Ihereby
broadening
the
listening
area of the stereo
sound
.
Therefore,
you can enjoy
the
slereo
sound
as
if
you were in
a
concert hall.
• Booster
Switch
When
this
switch
is
set to
"ON",
the sound level is boosted
.
AM:
A sensitive ferrite core antenna is built in
this set to assure excellent AM
reception in
most areas.
To improl/e
Ihe
recepti
on
of weak stations,
turn the set
in
the direction which
gil/es
the best
results.
-4
Quicklinks ausblenden:
Werbung
Inhaltsverzeichnis
