Disposal; Ordering Spare Parts - gemm BCB/24 Bedienungsanleitungen

10 – DISPOSAL
10.1 – DISPOSAL METHOD
APPLIANCE STATUS
electronic circuit board in position "O" (OFF);
-
- power plug disconnected from the mains supply.
METHOD
The appliance is made of ferrous materials, electronic components and plastics. If it needs to be scrapped, separate the
various components according to the material of which they are made in order to simplify separate waste collection or
possible recycling of parts. The appliance must be disposed of separately from municipal waste.
No special instructions apply to the disassembled appliance. Consign to specialised waste disposal firms or return to the
dealer, if allowed by law (also see "Information to users regarding waste disposal in the European Union" below).
With regard to disposal and scrapping, always consult the laws applicable in the country where the appliance is used
(also see "Information to users regarding waste disposal in the European Union" below).
TAKE
CONTROLLED AND RECOVERED ACCORDING TO THE REGULATIONS OF THE COUNTRY IN
WHICH DISPOSAL WILL TAKE PLACE.
Consult the fitter for any disassembly requirements.
INFORMATION TO USERS REGARDING WASTE DISPOSAL IN THE EUROPEAN UNION
The symbol of a crossed waste bin on the appliance indicates that at the end of its working life the product must be
collected separately from other waste.
At the end of its working life the user must therefore take the product to a suitable centre for the separate collection of
electronic and electrical waste, or return it to a dealer when purchasing a new appliance of the same type.
Suitable separate waste collection of unwanted appliances and their forwarding to recycling, treatment, recovery and
environmentally friendly disposal makes it possible to avoid potential negative effects on the environment and human
health, and assists recycling and recovery of materials.
Unauthorized disposal of the product by the user is punished by the application of fines established by the countries in
which the appliance is disposed of.
11 – SPARE PARTS
11.1 – ORDERING SPARE PARTS
Contact the manufacturer or authorized dealer to order spare parts.
12 – ENCLOSURES
The appliance comes with the following enclosures:
- Declaration of conformity
- Wiring diagram
- Electrical approval report
- Assessment of vacuum, leakage and gas load for the refrigeration system.
BCB_N Rev.05 05-2015
CARE: THE APPLIANCE CONTAINS REFRIGERANT GAS THAT MUST BE
pag. 40