ProFlow PF-AG1 Installation- & Gebrauchsanleitung Seite 10

PROGRAMMING INSTRUCTIONS -
BASIC SETTINGS

Before entering the programming mode, make sure that
the appliance is in the service mode.
1. Press the scroll button; the display will show:
Language:English
Press the up or down

language.
2. Press the scroll button again; the display will show:
Set time:
Press the up button or down

time of day.
3. Press the scroll button again; the display will show:
Interval:4 Days
Press the up or down

of days between regenerations.

The regeneration cycle is necessary to wash out
impurities that are captured in the filter media during the
service cycle, and to prevent 'caking' of the filter media,
which may result in an increase of pressure drop over the
water filter. Typically a regeneration every 4 days should be
sufficient. In case of high flow rates, excessive water usage
or a high concentration of impurities in the incoming water,
it may be necessary to lower the number of days between
regenerations.
EN - English
ELECTRONIC CONTROL PANEL
button to set the
8:01
button to set the
button to set the number
Page 10