Velleman SG81030 Bedienungsanleitung Seite 5

• Control Centre Number & Health Reporting Schedule Setup
These two values are configured by one single command.
(1) The control centre number is the phone number receiving the periodic report and regular report. Besides
the periodic report on schedule (command 5: power-up message), report of any command will be sent to this
number in addition to the mobile phone number sending the command. Maximum 2 control centres can be
defined.
Command: PWD:XXXX,CTRZ:YYYYYYYYYYY,MM#%
XXXX Password
Z Control centre number (max. 2 centres)
1 means 1
2 means 2
YYYYYYYYY Phone number in control centre
MM Period code of automatic scheduled health report
Example:
PWD:1234,CTR1:123456789,04#%
Password: 1234
Reporting health status every hour (refer to the reference table below)
(2) The periodic health report and any command from another mobile phone will be reported to the first control
centre with number 123456789.
Reference table for the automatic scheduled health report
00 No automatic report
01 Every 5 minutes
02 Every 15 minutes
03 Every 30 minutes
04 Every 1 hour
05 Every 2 hours
06 Every 3 hours
The CU2200 automatically reports the unit's health status on a pre-defined schedule via an SMS message.
[SMS message received]
ST:XXX;T:2006/10/08/06:15;V:XXXX;A1:0000;A2:0000;K1:X;K2:X;K3:X;K4:X;K5:X;K6:X;K7:X;K8:X;OUT1:1;O
UT2:1;OUT3:1;#
ST Unit serial number
T Unit internal clock
V Operating voltage
K1 Alarm channel 1
K1:0 means closed
K1:1 means open
OUT1 Relay output 1
OUT1:0 means open
OUT1:1 means closed
CU2200_v5
www.electronicaembajadores.com
centre number
st
centre number
nd
07 Every 6 hours
08 Every 12 hours
09 Every day (08h00)
10 Every odd day (08h00)
11 1 , 7 , 14 , 21
st th th st
12 1 , 15 day (08h00)
st th
13 1 day of each month (08h00)
st
XXX ASCII code
XXXX Year/month/day/time
XXXX
K1 ~ 8 Alarm channel 1 ~ 8
OUT1 ~ 3 Relay output 1 ~ 3
5
, 28 day (08h00)
th
VELLEMAN