Operating Instructions; Overview; Operating The Compressor; Filling A Tyre Using The Car Valve (Schrader Valve) - Eufab 21076 Bedienungsanleitung

6. Operating instructions

6.1 Overview

Figure 1: Front view
1 Carry handle
2 Manometer
3 On/Off switch for 12 V mode
4 On/Off switch for 230 V mode
5 Cable for 12 V vehicle connection
(230 V cable not visible on image)
6 Valve connection for air hose
7 Storage compartment lid
8 Fuse holder (230 V)

6.2 Operating the compressor

In order to be able to work with the compressor, first take the air hose (Position 6 in the overview) and the connection cable
(Position 5 in the overview) from the storage compartment (Position 7 in the overview).
Make sure that the compressor is switched off before connecting it (both switches, Positions 3 and 4 in the over-
view, may not be pressed).

6.2.1 Filling a tyre using the car valve (Schrader valve)

Open the lock on the valve
connection
Figure 5
Connect the compressor to the power supply. Either to the 12 V connection in your vehicle or to a 230 V household connection.
CAUTION: Do not connect the compressor to both the 230 V household connection and the 12 V socket
of your vehicle at the same time.
Switch the compressor on to fill. When connecting to a 12 V vehicle socket, press the right switch (Position 3 in the over-
view) on the front of the device. When connecting the compressor to the 230 V household network, press the left switch
(Position 4 in the overview).
The manometer (Position 2 in the overview) is designed to monitor the air pressure. When the desired air pressure is re-
ached, switch off the compressor by pressing the appropriate On/Off switch. Remove the valve connection in reverse order
(Figures 8 – 5).
8
Figure 2: Rear view
Place the valve connection
on the valve
Figure 6
Figure 3: View of adapters and fuses
Figure 4: Side view
9 Replacement fuse (12 V)
10 Adapter Ø 8 mm
11 Adapter Ø 5 mm
12 Ball adapter
13 Replacement fuse (230 V)
14 Ventilation slots
Lock the valve connection
Figure 7
You can now fill the tyre using
the compressor
Figure 8