Extel WECR 70510 SER.R1 Bedienungsanleitung Seite 20

INSTALLING THE CALL BUTTON
Before drilling the mounting holes, position the rain shield and place the button in the intended location (pic 4). Place the chime inside the house
then press the call button to check that the signal is received correctly.
Use a small screwdriver to remove the rear cover from the call button. Position this cover in the shield and assemble the two parts using the screws
provided. Insert the front part of the button on the rear panel, checking that the button on the circuit board is correctly aligned with the call button.
IMPORTANT : The call button must be fixed horizontally, the 2 holes for ventilation downside (pic 4).
Reminder : don't forget to set the plastic protective casing device back in order to guarantee the protection of the printed circuit.
Note : As with all wireless chimes, the transmission range will be considerably reduced if the call button is installed on a metal surface.
MODIFYING THE COMMUNICATION CODE
The chime has a number of microswitches for changing the code used between the call button (emitter) and the chime (receiver).
There is no need to change this code unless your chime suffers from interference or is not correctly activated.
As mentioned above, the chime and call button each contain a row of microswitches numbered from 1 to 8. To change the code, simply alter the
position of one or more microswitches from 1 to 8. Positions 1 to 8 must be identical in the chime and the call button. (caution with the position
«ON») (pic 3 - 5)
SETTING
Use the potentiometer on the rear of the chime to adjust the volume.(pic 5)
3 Settings : flash only, ring tone only, flash+ring tone (pic 6)
4GB
CFI EXTEL WECR 70510 SER.R1 - 05/2011 - V1