GAUI Hurricane 255 Bedienungsanleitung Seite 47

Programming the Gyro
The gyro is programmed with the SET button and the tail control lever of the transmitter. Do not leave too long of a break
between the individual programming steps; otherwise, the gyro will react incorrectly. In this case, switch off the gyro's
power supply and take it into operation again after a few seconds.
• For this, take the gyro into operation in AVCS mode so that the
LED S lights up green.
• Keep the Set button pressed for approx. 3 seconds with a small
screwdriver.
• Release the SET button when LED 1 is lit.
• LED S changes colour from green to orange to indicate
programming mode
Servo Type Selection
• Use the tail control lever to switch the light colour of LED 1 and
to thus select the required servo type.
Green = digital servo
Red = analogue servo
Changing the Rotating Direction of the Tail Servo
• Press button SET again.
• LED 1 goes out and LED 2 lights up.
• Use the tail control lever to switch the light colour of LED 2 and
to thus select the servo direction.
Green = normal direction
Red = reverse direction
S 1 2 3
S 1 2 3
S 1 2 3
SET
3 sec.
Figure 7
SET
Figure 8
SET
Figure 9
47