Y-cam Outdoor HD Pro Schnellstartanleitung Seite 9

Installing your HD Pro on a wall
If using Wi-Fi, before mounting, ensure your camera is in a position where Wi-Fi is accessible
1
Option 1
2
3
Work out where you want the camera to be
placed, and drill two holes for the stand cap.
Prepare your cabling to the centre of this point,
either along the wall or through the wall (See
Picture 1) (Power cable if using Wi-Fi, power
cable and/or ethernet cable if using network
connection or PoE), bearing in mind the cabling
will be going straight in to the back of the camera
Option 2
- so all excess cable should be removed, with the
cable connectors as close to the centre of the
base plate as possible.
Position the rubber grommet over the cables
between the two screws, channeling the cables
through the groove if required (See Picture 2)
The grommet only fits into the stand cap one way.
Position the stand cap over the wires, affix the
grommet into the cap, and then screw the cap to
the wall, ensuring the grommet is flush against
the rear of the stand cap (See picture 3)
Prepare the camera and stand for mounting
(attach Wi-Fi aerial, tighten ball joints slightly,
move sun shield, etc as needed for your setup)
Note: Ensure all excess cable is is removed as
excess cable will not fit in the camera mount.
9