Get Started - SodaStream source Bedienungsanleitung

GET STARTED – ASSEMBLY
1. Place Drinks Maker on flat, sturdy surface, in an upright position. Remove packaging
materials. To remove back cover: (i) Put your index finger in the hole;(ii) Grasp back
cover; and (iii) Pull away from unit. Set cover aside.
2. Remove seal and cap from cylinder. Tip Drinks maker forward and insert 60L*
cylinder into Drinks Maker: first downward into the hole in the base of the Drinks
Maker, and then upward into the valve fitting.
3. Turn cylinder clockwise until it stops. Hand-tighten only; DO NOT use tools.
4. Reinstall back cover: tilt back cover toward you; insert bottom tab into slot and push
the cover into place.
* The 60L cylinders produce up to 60 litres of sparkling drinks, depending on the level
of carbonation and type of Drinks Maker used.