Troubleshooting - SodaStream source Bedienungsanleitung

TROUBLESHOOTING YOUR SOURCE DRINKS MAKER
Before you call for service, check the list of problems and solutions below:
DRINKS MAKER DOESN'T WORK:
You might be out of gas; replace your cylinder.
Check that carbonating bottle has been filled up with water to the fill line.
Ensure that the Drinks Maker is always in the upright position.
Cylinder may be loose. DO NOT use tools. Detach the bottle, open the rear cover, and
retighten the cylinder. Apply firm pressure but do not over tighten. If the cylinder is
already firmly in place, it may be empty. Replace with a full cylinder.
WARNING: Use caution when removing cylinder as it may be very cold.
CANNOT PULL BOTTLE LOADER TAB:
Make sure carbonating block is in its fully upward position.
Pull bottle loader tab firmly towards you.
CANNOT GET THE BOTTLE IN:
Make sure the carbonating block is in its fully upward position.
Pull the bottle loader tab toward you until it clicks
Insert bottle into Snap-Lock
Firmly push bottle up and back until it locks.
CANNOT GET THE BOTTLE OUT:
Make sure the carbonating block is in its fully upward position.
Pull the bottle toward you.
YOU HEAR GAS ESCAPING FROM THE BOTTLE:
Bottle may not be properly attached. Allow the Drinks Maker to finish the carbonation
process and then you can detach the bottle and reconnect it, following the
instructions in the "Make Sparkling Water" section.
It is normal to hear a small amount of gas escape at the end of the carbonating
process.
WANT TO RE-CARBONATE A DRINK THAT WAS ALREADY
CARBONATED:
WARNING: FOR YOUR SAFETY: NEVER carbonate again after you add the flavour.
If you have not added Sodamix, you may recarbonate only water, as explained in
"Make Sparkling Water" section.
DANGER: IF YOUR DRINKS MAKER CONTINUES TO RELEASE GAS
AFTER CARBONATION IS FINISHED:
DO NOT REMOVE THE CYLINDER OR THE BOTTLE. LEAVE THE DRINKS MAKER IN
AN UPRIGHT POSITION. DO NOT TOUCH IT UNTIL YOU NO LONGER HEAR GAS
ESCAPING. When the Drinks Maker is no longer releasing gas, remove the
carbonating bottle, and contact your local SodaStream customer service.
IF AFTER INSTALLING A NEW CYLINDER INTO THE DRINKS
MAKER YOU HEAR THE SOUND OF LEAKING GAS:
There may be a pressure leak between the cylinder holder and the valve. Screw the
cylinder tighter into its fitting. DO NOT use tools.