Troubleshooting - Yard Force SA900 Bedienungsanleitung

Trouble Shooting For Charging Station
LED
1 Blue light on
2 Blue flash, Red off Charging station internal wire break, main Boundary is OK
3 Red flash, Blue off
4 Red and Blue flash
Main Customer Trouble Shooting
No. Message
1 NONE
2 NONE
3 NONE
4
flash

TROUBLESHOOTING

Normal
Boundary cut off or poor connect, charging station internal wire
is OK
Boundary and charging station internal wire both short circuit or
cut off
type of
Symptom
message
blank screen
Your Mower
cannot enter the
charging station
The mower turns
around in circles
when running
back to Charging
station along the
boundary wire.
Note In the process of
message charging
Description
1. Confirm the Isolated switch is
"ON".
2. When you first use the mower the
battery may not be fully charged
please switch off and then carry
the mower to charging station,
once positioned in charging
station turn on switch again.
3. For normal working, press start
key on control panel, then start
the mower. If mower does not
work, enter Error menu and
check fault code, once the fault
has been detected it can be
corrected and mower can then
cut.
4. In normal working if you press
any key on control panel, but
the screen is still blank carry the
mower to charge station. After 5
minutes, you can follow step 3
1. Check if boundary wire under and
in front of the charger is straight
line.
2. Check that the charging station
is positioned according to clause
4.3.
Check if there is high power
cable close to Boundary wire
or underneath it, if there is then
avoid the area by changing the
position of the boundary wire
Proper function
52
Action