Pepcare 9143915 Bedienungsanleitung Seite 17

Shaving head attachment
1. Press the unlocking button (4) and remove the shaving head from the
appliance.
2. Push the shaving head down until it locks in place with an audible click.
NOTE: Inserting the shaving head is possible only if the drive wheel of the
shaving head is above the drive wheel of the appliance.
For thorough cleaning, it is possible to remove
the shaving attachment from the shaving head
(see figure).
Switching on
1. Pull the protective cap (1) off the appliance.
2. Switch on the appliance by pushing the on/off switch
• Level 1 (slower speed) for areas of the body which are particularly sensi-
tive or difficult to access.
• Level 2 (higher speed) for faster epilation on larger and less sensitive
areas of the body (e.g. legs, arms).
Epilation
DANGER! Particular care should be taken when used on sensitive
areas of the body (bikini line, armpits, etc.).
Wash your legs thoroughly with warm water and soap to provide the best
starting conditions for epilation.

30
1. Do not apply body lotions or other substances (e.g. shaving foam) to
2. Rub over your legs with a rough sponge or luffa sponge against the direc-
3. Pull the skin tight (figure 1).
4. Switch the appliance to the desired speed.
5. Place the appliance at an angle of approx. 90 ° onto your leg, whereby
6. Guide the appliance in circular movements over the leg and allow it to
figure 1
;
(5) up.
Shaving
Long hair trimmer:
• Use the two long hair trimmers to shorten longer hairs.
• The straight trimmer serves to shave longer hairs on flat areas of the skin
avoid that the hair cannot be captured by the epilator.
tion of hair growth so hairs growing into the skin stand up.
the front of the appliance should face upwards (figure 1).
slide over the skin without additional pressure (figure 2).
figure 2
while the rounded trimmer is used for shaving longer hairs in the armpits
or bikini area.
rounded long hair trimmer
straight long hair trimmer

31