Charging; Preparation And Operation - Pepcare 9143915 Bedienungsanleitung

04. Charging

NOTES:
• Prior to the first use without cable, the batteries should be charged for at
least 12 hours. A charging time of 10 hours is sufficient for the following
charging processes.
• In order to maximise the battery life, you should allow the batteries to
completely discharge before recharging them.
• The epilator runs on 2 NiMH high performance batteries with protection
against overcharging. The batteries can be recharged without a risk of
overcharging or lowering performance.
• Please note that the battery capacity will decrease during extended peri-
ods of storage. For this reason, long recharging times should be avoided
because of the interruption between the charging and discharging cycles.
1. Place the shaver on a level surface.
2. Connect the wall power supply to the shaver.
3. Insert the wall power supply into an easily accessible power point.
4. The power ON/OFF LED (6) lights up red during the charging process and
as long as the appliance is connected to the mains. The power ON/OFF LED
goes out when the appliance is switched on.
5. After the battery is fully charged, the appliance can be operated cordless-
ly for about 50 minutes.
6. Unplug the wall power supply from the grounded socket and from the epilator
as soon as the battery is fully recharged.
7. If the epilator stops during operation due to its batteries being insufficiently
charged, you can continue epilating/shaving by connecting the appliance to
the wall power supply.

28

05. Preparation and Operation

WARNING!
Do not use if the cutting parts of the attachment are damaged.
• Do not use any aggressive or scratching cleaning products.
Irrespective of the charging state of the battery, you are always able to use
the epilator connected to the mains power.
1. In order to use the epilator connected to the mains power, ensure that the
appliance is switched off.
2. Connect the wall power supply to the appliance.
3. Insert the wall power supply into an easily accessible socket.
4. Take off the protective cap.
;
5. Use the on / off switch (5) to switch on the epilator.
Attachments
Scope of delivery comprises an epilation attachment with 18 staggered pairs
of tweezers including an epilation head frame.
For shaving, a shaving attachment with two integrated long hair trimmers is
included with the appliance.
Inserting / Replacing the attachments
Epilation attachment
1. Use your thumb and index finger to press the epilation head frame (2)
slightly inwards on both sides (
2. Press the unlocking button (4) and remove the epilation head from the
appliance.
3. Push the epilation head down until it locks in place with an audible click.
4. Attach the epilation head frame to the epilation head in such a way that
the concave side points towards the front. The epilation head frame must
lock in place with an audible click.
NOTE: Inserting the epilation head is possible only if the drive wheel of the
epilation head is above the drive wheel of the appliance.
▲
) and remove it from the epilation head.
●

29