Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Hair trimmer
Connection to the mains supply
Make sure that the supply voltage
corresponds with the voltage marked on the
rating label of the adapter.
Charging process
Before using the appliance for the first time
the battery must be fully charged for a
period of approximately 10 hours. However,
the appliance can remain on charge for a
longer period without damage or danger.
Should you experience a considerable
decrease in trimming performance, switch
off the appliance and recharge the battery.
The hair trimmer may also be used by
means of the adapter. In this case, however,
the battery must be briefly charged for
approximately 10 minutes. The charging
process starts only once the unit is switched
off and is visible by the charge indicator.
- Insert the connecting plug of the adapter
into the corresponding jack on the
charging base.
- Ensure that the hair trimmer is switched
off and placed into the charging base.
- Insert the adapter into a suitable wall
socket. The charging process begins
automatically and is visible by the charge
indicator. The charge indicator remains
lit as long as the charging base is
connected to the mains power.
The charging process only starts if the
unit has been switched off.
- Once the charging process is complete,
always remove the adapter from the wall
socket first before disconnecting the jack
from the charging base.
- The battery can also be recharged by
inserting the connecting plug of the
adapter directly into the connecting jack
on the hair trimmer.
- Whilst charging, the transformer within
the adapter will become warm. This is
perfectly normal and safe and does not
indicate a malfunction of any kind.
- If the appliance has not been used for a
long period of time, the capacity of the
battery may decrease by a certain
amount. However, full capacity will be
restored
charging/discharging cycles.
Use
Adjusting the cutting length
The push-on attachment comb supplied
allows for a step-by-step cutting length
adjustment between 4-20mm. The cutting
length can be gradually adjusted in 7
positions by using the adjustment slide
control; to adjust, simply press the
adjustment slide control button and select
the desired cutting length. The following
lengths can be selected: 4mm, 7mm, 9mm,
12mm, 15mm, 17mm, 20mm.
To remove the attachment comb, set the
adjustment slide control to its lowest position
and pull the attachment comb off.
Operation
●
Before each use, always put a few drops
of acid-free oil between the trimming
comb and the trimming blade.
- Always start with the largest setting of
the push-on comb.
- The hair should first be combed, and
then generally cut against its natural
direction.
- For longer hair-cuts use the push-on
comb or a normal comb.
- Cut from bottom to top with the
trimming comb lying against the head;
lead the appliance upwards through the
hair, moving it gradually away from the
head at the same time.
- For a shaped cut, reverse the appliance
and shorten the hair from top to bottom
without using the push-on comb.
Removing the batteries
- The batteries can be taken out after one
half of the housing has been removed.
Use a small screwdriver to loosen the
screws, then cut the terminal wires one
9
after
several
Werbung
