Velleman CS150 Bedienungsanleitung Seite 4

3. Turn the stem's lock nut anticlockwise to lock it in place.
4. Unscrew the knob on the search coil and remove the knobs and connector. Insert
the stem and align the holes on the search coil bracket and the stem. Push the
connector through the holes and tighten the knob.
5. Wind the search coil cable around the stem. Leave enough slack in the cable to let
you adjust the search coil when you are hunting on uneven ground.
6. Insert the search coil's plug into the search coil jack on the detector's control
housing. Be sure the pins on the plug align with the holes in the jack.
Caution:
• The search coil's plug fits into the connector in only one way. Do not force the
plug or you could damage it.
• To disconnect the search coil's cable from the detector, grasp the plug and pull it out of the connector. Never
tug at the cable.
7. Loosen the knob at the search coil's end and adjust the search coil to the desired
angle. (The search coil should be parallel with the ground). Tighten the knob just
enough to keep the search coil from rotating or wobbling.
Caution: Do not tighten the search coil too hard or use tools such as pliers to
tighten it.
8. Loosen the knob at the base of the handle, insert the arm support,
and tighten the knob.
b. Installing the Batteries
Caution:
• Use only fresh batteries of the required size and recommended type.
• Do not mix old and new batteries, different types of batteries (standard, alkaline or rechargeable batteries of
different capacities).
1. If the detector is on, turn VOLUME (on the control housing) to OFF.
(The control clicks)
2. Press the right battery compartment cover's tab and slide the cover off in the direction of the
arrow.
3. Place a 9-volt battery into the battery compartment on top of the ribbon, matching the polarity
symbols (+ and -) marked inside.
4. Replace the right battery compartment cover.
5. Press the left battery compartment cover's tab and slide the cover off in the direction of the
arrow.
6. Place two 9-volt batteries into the battery compartment on top of the ribbons, matching the
polarity symbols (+ and -) marked.
7. Replace the left battery compartment cover.
CS150
- 4 -
VELLEMAN