Operation - ClickTronic HC 428 Bedienungsanleitung

RS-232 Operation
The power main switch is located at rear panel of the splitter. Please
switch it to turn on the power of the splitter. The LED indication light
of power will be on.
1
Stand by and power on control:
When you run the software, the power is set to on (The button will
show "Stand By"). Press the "Stand By" button. The Splitter will
be turned to stand by mode. (The button will show "Power ON")
2
COM port select:
The software can control up to 15 COM ports. Scroll down the menu
and select the COM port you want to control. (Normally the COM 1
and COM 2 are RS-232)
3
Input source select:
2 input source selectable. Press "IN 1" or "IN 2" to select the input
source. After the source is selected, the input indicator will display
green color.
4
Output port control:
8 output source controllable. Press "OUT 1" ~ "OUT 8" to control
the output signal. A check mark will show if you choose to turn on
the output port.
5
Power indicator:
Red (ON); Gray (Stand by)
6
Input indicator:
Input source indication. (Green: selected; Gray: non-selected)
7
Output indicator:
Active or non-active output port indication. (Blue: Active)
8
Exit the Software:
Press to exit the software.

Operation

• Turn on with the main switch on the rear side of the device.
• The LED operating display POWER INDICATOR is lit.
• In order to turn the switch to standby or to switch it on again,
shortly press the button POWER ON/OFF on the remote control or
push the key SELECT on the device for about 3 seconds.
• Activate the HDMI input on your screens (see instructions of the
11