A4Tech WIRELESS DESKTOP ERGO A-SHAPE Bedienungsanleitung Seite 5

the battery compartment casing.)
3. Replace the cover.
Installing the Mouse Software and Keyboard
software
Windows 98/Me/2000/XP installation
1. Insert the installation diskette into your floppy disk drive.
2. Click the Start button and then click Run.
In the Run dialog window, type A:\setup, where "A" is the
3.
letter of your floppy disk drive.
4. Click OK and follow the instructions on your screen to
complete the installation.
Receiver works as a charger:
The receiver can work as a charger which you can put the spare
batteries on the charging compartment. The LED (M) light shows you
that the mouse is working properly. The LED (M) is the charging
LED. The bright red light shows you that the batteries are low and
when the light turns to dim, it implies the battery power is fully
charged. The green LED (N) light shows you that the keyboard and
mouse IDs are connected
M
N
The Wireless keyboard and mouse ID code
Each keyboard and mouse is assigned a unique ID code when produced,
so the receiver only picks up the signal from your mouse and prevents
other Wireless keyboard or mouse radio signals from operating on your
computer.
Connecting the wireless keyboard and mouse ID
codes
Manually establish a communication between the receiver for the
keyboard and mouse.
(a) Press any key on the keyboard and move the mouse
(b) Press the ID Connect button (O) on the receiver (J): the green
LED (N) light shows you that the keyboard and mouse IDs are
connected. If the green LED light is off then the keyboard and mouse
IDs are disconnected.
3
N
O
J