Intended Use; Mounting And Connecting; Preparation; Mounting - Goobay 58890 SPW IT 1000 Betriebsanleitung

User manual
Weight (kg)
All 4 battery
cables must be
used.
Childlock
Tab. 3: Specifications
3

Intended Use

We do not permit using the device in other ways like described in chapter
"Description and Function" and „Safety Instructions". Not attending to these
regulations and safety instructions might cause fatal accidents, injuries, and
damages to persons and property.
4

Mounting and Connecting

4.1

Preparation

1. Check the battery terminals before connecting.
2. If the positive pole „+" connected to a metallic part of the vehicle, the
voltage converter must NOT be used with this vehicle.
3. Use the battery cable with ring terminals for connecting to the vehicle
battery.
The vehicle battery discharges when the vehicle is not in operation.
4. Check the delivery for completeness and make maintaining its integrity.
4.2

Mounting

• Mount the voltage converter with suitable screws in the vehicle interior
>> on stable and leveled places,
>> on clean, dry and nonflammable surfaces,
>> in well-ventilated areas.
Mounting screws are not included.
4.3

Connectiing to the vehicle battery

• Attend to correct polarity.
• Avoid a short circuit of the battery terminals.
1. Loosen the terminal screws of the plus and minus pole at the rear side of
the voltage converter.
2. Put the red battery cable (10) straighht in the DC-input „+" (3) and tighten
the terminal screw.
3. Put the black battery cable (10) in the DC-input „-" (1) and tighten the
black terminal screw.
17
1.85 2.30
-
Short circuit!
5.30 6.00
for loads > 1000 W
Shutter
5.30 6.00