Technical Data; Care And Cleaning; Declaration Of Conformity (Doc) - BASETech 1680332 Bedienungsanleitung

868 MHz reception test
The weather station should receive and display the outside area data within 5 minutes after
being put into operation. If they aren't displayed within 5 minutes after the basic setting or if
the signal reception in normal display mode is continuously jammed so that the outside area
display only shows "- - -" then please check the following:
1. The distance of weather station and outside transmitters to sources of interference such as
computer monitors or television sets should be at least 1.5 - 2 meters.
2. Avoid placing the units directly against or in the vicinity of metal doors or window frames.
3. The use of other devices working on the same frequency (868 MHz) such as headphones
or loudspeakers can prevent correct signal transmission.
4. Reception interference can also be caused by neighbours who operate devices working on
the same frequency (868 MHz).
If the 868 MHz signal is correctly transmitted and received, then the battery cases
of the weather station and outside transmitters should no longer be opened. The
batteries could thereby become disengaged from the contacts and thus bring about
an unwanted reset. If this should nonetheless occur, then all units have to be set
anew to avoid transmission problems (see "Basic setting" above).
The transmission range of the outside transmitter to the weather station in a free
field is about 100 meters. However, this depends on environmental conditions and
possible sources of interference. If reception is not possible despite consideration of
all the factors mentioned above, then all units have to be reset (see "Basic setting"
above).
Mounting
Before permanently mounting the brackets, please place all units in the desired
installation or mounting locations and check whether the outside area data are
correctly received. If this is not the case, then in most cases a slight shift of mounting
locations is sufficient for adequate signal reception.
Placement of the outside temperature transmitter
The bracket can be fixed at both
ends of the outside transmitter so
that it can be mounted on any flat
surface.

Care and cleaning

• Remove the battery before cleaning.
• Do not use any aggressive cleaning agents, rubbing alcohol or other chemical solutions as
they can cause damage to the housing and malfunctioning.
• For cleaning of displays and enclosures, use only a soft, slightly moist cloth.
• Do not immerse the product in water.

Declaration of Conformity (DOC)

Conrad Electronic SE, Klaus-Conrad-Straße 1, D-92240 Hirschau hereby declares that this
product conforms to the 2014/53/EU directive.
Click on the following link to read the full text of the EU declaration of conformity:
www.conrad.com/downloads
Select a language by clicking on a flag symbol and enter the product order number
in the search box. You can then download the EU declaration of conformity in PDF
format.
The bracket can be mounted on a wall by means of two
screws provided.
1. For this, fasten the bracket with the help of screws
and dowels at the desired spot on a vertical
surface.
2. Fasten the outside transmitter into the bracket.
Disposal
a) Product
Electronic devices are recyclable waste and must not be disposed of in the
household waste. At the end of its service life, dispose of the product according to
the relevant statutory regulations.
Remove any inserted (rechargeable) batteries and dispose of them separately from
the product.
b) (Rechargeable) batteries
As the end user, you are required by law (Battery Ordinance) to return all used
(rechargeable) batteries; disposal of them in the household waste is prohibited!
Contaminated (rechargeable) batteries are labelled with this symbol to indicate that
disposal in the domestic waste is forbidden. The designations for the heavy metals
involved are: Cd = Cadmium, Hg = Mercury, Pb = Lead (name on (rechargeable)
batteries, e.g. below the trash icon on the left).
Used (rechargeable) batteries can be returned to collection points in your municipality, our
stores or wherever (rechargeable) batteries are sold.
You thus fulfil your statutory obligations and contribute to the protection of the environment.

Technical data

Power supply ....................................... 2 x 1.5 V AA batteries, alkaline batteries recommended
Temperature measuring range ............-39.9 to +59.9 ºC with 0.1 ºC resolution
Transmission of outside area data.......every 4 seconds
Dimensions (W x H x D) ......................21 x 128 x 38 mm
This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com).
All rights including translation reserved. Reproduction by any method, e.g. photocopy, microfilming, or the
capture in electronic data processing systems require the prior written approval by the editor. Reprinting, also in
part, is prohibited. This publication represent the technical status at the time of printing.
Copyright 2018 by Conrad Electronic SE.
e.g. Item No. 650117-66
*1680332_V1_0818_02_mxs_m_en