Werbung
STIMA-CLS
STIMA-CLS
Core thickness
MODEL
ELECTRIC SPECIFICATIONS
Power supply
(2)
Medium consumption
Standby consumption
ENVIROMENTAL SPECIFICATIONS
Operating temperature
Operating humidity
Storage temperature/humidity
(w/o paper)
BARCODE READER SPECIFICATIONS mod.CX002
Scan rate
Sensor
Light Source
Ambient Light (Fluorescent lamp)
Resolution
Readable Barcode
TRANSPONDER SPECIFICATIONS
Supported transponders
NOTE:
(1)
: "Veramono.ttf" and "Mono.ttf" are installed
on printer fl ash disk. It is possible to install
GB
more TrueType fonts.
(2)
: Referred to a standard receipt (L=10cm,
Density = 12,5% dots on).
(3)
: Electronic board.
(4)
: For external rolls diameter higher to
Ø100mm it's recommended to use a paper
pretensioning device.
(5)
: Only for models equipped with barcode reader.
(6)
: Only for models equipped with RFID Reader/
writer.
200 dpi
35 W
(5)
ALL UPC/EAN/JAN , Code 39, Code 39 Full ASCII, Code 128,Code 93,
Interleave 25, Industrial 25, Matrix 25, China Postage, CODABAR/NW7,
Code 11,MSI/PLESSEY, Code 32, PDF417, DATAMATRIX
(6)
ISO159693 (icode),
ISO1443-MIFARE® (MIFARE Ultralight, MIFARE 1K, MIFARE 4K)
<30>
Appendix
Appendix
2 mm (+1 mm)
100Vac ÷ 240Vac
9 W
0-50°C
10-85% Rh
-20 °C – 70 °C / 10% - 90% Rh
200 scans/sec
Linear CCD Sensor
Red Leds, 639 nm
3000 LUX MAX
5 mil. (0.127 mm)
NOTE:
(1)
: Nella stampante sono già installati i font
"Monovera.ttf" e "Vera.ttf". E' possibile
I
installare font aggiuntivi.
(2)
: Riferito ad uno scontrino tipico (L =
10cm, Densità = 12,5% dots accesi).
(3)
: Scheda elettronica.
(4)
: Per rotoli con diametro esterno superiore
a Ø100mm è consigliato l'utilizzo di un
ammortizzatore carta.
(5)
: Solo per modelli con lettore barcode.
(6)
: Solo per modelli con lettore/scrittore RFID.
300 dpi
51 W
Werbung
