EnviteC AlcoQuant 6020 Gebrauchsanweisung Seite 27

Start active mode measurement
Dok.-Nr.: 059-07-11000300-k.doc / 07.08
After switch-on the
automatically in the active mode and the
Display shows "Ready"
The measurement is started automatically by
blowing-in the expiration air.
Start
During sample collection the test person
must breathe into the device with a
sufficiently large respiratory flow, evenly and
without interruptions. A breathed air volume
from 1.2 liters must achieved.
Audible + Optical Signal
A proper blow-in procedure is indicated by
an audible signal and the flashing yellow
LED.
End
The blow-in procedure is finished if no
audible signal is present and the yellow LED
turns off.
Evaluation and display of measured values.
Save measured values.
Press key to set device in operating mode
for a new measurement.
AlcoQuant 6020
device operates
27