C Troubleshooting - Epak-Tv Basic Line Tv44 Handbuch

C Troubleshooting

Display Problem
no dish No connection to the antenna
unit
Communication error with
ErrorCom
antenna unit
Low Batt Power supply too low (>11.5V) - Check power supply connection for anten-
no Data The satellite position requested
by the receiver in Auto Sat
mode is not stored in antenna
unit
Err HR
Read error of horizontal unit
Err HW Write error of horizontal unit
Err VR Read error of vertical unit
Err VW
Write error of vertical unit
Err SR
Read error of signal process-
ing unit
Err SW
write error of signal process-
ing unit
Err VCO
Error during satellite inspec-
tion
Err EEP
Error during storage
Err IIC
Error in internal communica-
tion
Err Trck
Error in tracking module
Err ULS Error in upper limit switch
Err LLS Error in lower limit switch
28
English
Remedy
- Check cable connection to antenna unit
(power and antenna cable)
- Check antenna unit's power supply
Turn unit off and on again
na unit (loose cable)
- Charge battery
- Check the DiSEqC™ adjustment of the
receiver
- Add satellite and store position (see sec-
tion 4.1)
Turn the unit off and on again. In case the
error reoccurs, call for technical assistance.
Display Problem
Err Comp Compass error
Err Save
Error while saving satellite
complete The search for a stored satellite
was successful, but no picture
is shown
Sat X inter- No reception of the stored sat-
changing with ellite
no Sig
scanning No receptable satellite in the
interchanging entire search range
with com-
plete
Cannot find a satellite
Cannot find a stored satellite
Search for stored satellite takes
longer, even though there are
no obstructions in the view to
the satellite
Remedy
Compass will automatically reset and recal-
librate. In case the error reoccurs several
times, call for technical assistance.
Repeat search and storing procedure. Make
sure the boat is not moving and no super-
structures obstruct the sight to the satellite
- Deactivate Fastscan mode
- Delete satellite storage positions and
memorize again
- Check if superstructures (e.g. steeple cab
or masts of proximate boats) obstruct the
sight to the satellite − if so, move the boat
- Reception can be briefly interrupted by
passing boats
- Check, if the program selected on the re-
ceiver is transmitted by the wanted satellite
- Check, if any superstructures are obstruct-
ing the sight to the satellite
- Check, by using footprint cards (e.g. www.
satcodx.com), that the boat is inside the cov-
erage area (footprint)
- Check, if superstructures obstruct the view
to the satellite, and restart the search mode
- Check, if superstructures obstruct the view
to the satellite
- Delete the stored satellite and restart the
search mode
If the location of the vessel changes, the an-
gles of the satellite may have moved. Modi-
fy angles of the satellite at the new location
with the function Upd Sat , see section
4.2.
29
English