Selection Of Stored Satellites; Manual Selection Of Satellites; Automatic Selection Of Satellites - Epak-Tv Basic Line Tv44 Handbuch

2. The display now shows Tracking . Press
Press  .
☛ Del Sat can only appear if there are satellites stored in the system.
3. The display shows Sat X, where X is the first satellite storage position to be deleted. Press
 and  .
4. The display interchanges between Sat X and Delete? . To confirm, press
don, press  .
5. If you chose 'confirm' the display shows complete for a brief moment. If you chose
'abandon', the display shows cancel .
6. In both cases, the display will return to Del Sat .
☛ If no further satellites are available for deletion, the display shows Tracking .
If there are more satellites in the system you wish to delete, press
you want to leave the menu, press  until quit appears and then press
Setup (flashing).
You are now back in the main menu and can switch to other satellites by pressing the
make adjustments in the setup menu.

5. 4 Selection of stored satellites

The satellite tracking system is able to switch between stored satellite positions (see chapter 4)
either by using the control box or the receiver (automatic).

5. 4.1 Manual selection of satellites

To select a satellite manually, follow the below procedure:
1. Press  repeatedly until the display shows flashing Sat X, where X is the satellite storage
position.
2. Select between the storage positions 1 -4 by pressing
☛ Only satellites already stored are shown.
The display interchanges between scanning and Sat X, where X is the desired storage posi-
tion. After the satellite is found, the display will continue to show X. The satellite tracking system
is now in TV mode.
22
English
 repeatedly until Del Sat appears.
 / to aban-
 and repeat from point 3! If
 . The display shows
 key or
 . Confirm with  .

5. 4. 2 Automatic selection of satellites

To select a satellite automatically, the receiver must support the DiSEqC ™ function. Further-
more, it is important that all satellites in the DiSEqC™ menu of the receiver and of the antenna
unit are stored under the same number!
☛ Example: Satellite Astra is stored under DiSEqC™ position 2 in the receiver, meaning that
this satellite has to be stored in the antenna unit under Sat 2 .
1. Press  repeatedly until the display flashes Auto Sat . Press
tenna unit will take over the satellite positions from the receiver. The display interchanges
between scanning and Sat X, where X is the desired storing position. After the satellite
is located, the display will continue to show Sat X. The satellite tracking system is now in
TV mode.
☛
If Auto Sat does not appear in the display, the feature is not supported by the receiver
(or not activated). The setting is "DiSEqC 1..4 " or similar. Refer to the user manual of the
receiver. The TV45 does not support this feature.
If the selected satellite is not stored in the antenna unit, the display interchanges between Sat X
(the selected storage position) and no Data . In this case, check the receiver parameters and
store the satellite in the antenna unit, meaning that the search mode has to be started again (see
chapter 4).
You can now switch to the main menu (flashing display) by pressing the
 . From now on, the an-
 key.
23
English