Special Product Features - Metabo BSZ 9.6 Gebrauchsanleitung

ENGLISH
ENG
Do not touch battery pack contact terminals or
short-circuit them.
Caustic fluid may leak from defective
NiCd or NiMH battery packs (30%
caustic potash solution)!
Slightly acidic, flammable fluid may leak
from defective Li-Ion battery packs!
If battery fluid from NiCd, NiMH or Li-Ion
battery packs leaks out and comes into
contact with the skin, rinse the affected area
thoroughly with water. If battery fluid leaks out
and comes into contact with your eyes, wash
them with clean water and seek medical
treatment immediately!
Machines with the designation BSZ...:
Only use suitable Metabo chucks (order no.
3.01.00.303.0) when using the machine.
5 Overview
See page 3 (please unfold).
1 Rapid-action keyless chuck
2 Selector barrel (torque, drilling, impact
drilling)*
3 Rocker switch for impulse function*
4 Slide-switch (1st/2nd gear)
5 Battery-pack release button
6 Battery pack
7 Depot for screwdriver bits
8 Trigger switch
9 Changeover switch (direction of rotation
setting, transporting safety device)
* depending on equipment

6 Special Product Features

Metabo impulse mode
(depending on equipment).
Optional pulse mode for precise fastening and
convenient drilling.
7 Operation
Charge the battery pack before use.
NiCd and NiMH: The battery pack reaches its
full capacity only after being charged and
discharged 5 times (charge cycles).
The maximum number of charge cycles can
only reached if an exhaustive discharge of the
battery pack is avoided. If performance dimin-
ishes, recharge the battery pack.
Store NiMH battery packs when charged and
recharge after 6 months at the latest.
10
Li-Ion battery packs (14.4 V and 18 V) have a
capacity and signal display:
- Press the button and the charge level is
displayed by the LEDs.
- If one LED is flashing, the battery pack is
empty and must be recharged. (The elec-
tronics protect the battery pack against total
discharge).
- If all LEDs are flashing, the battery pack has
become overloaded or too warm during
operation (temperature monitoring). The
battery pack has been switched off by the
electronics for protection. To continue using
the battery pack: For activation, insert the
battery pack into the charger, which is ready
for use.
7.1 Removing and replacing the battery-
pack
Removing
Press in the release button (5) and remove the
battery pack (6).
Replacing
Push the battery pack (6) fully into its housing
until it locks into position.
7.2 Setting the direction of rotation,
engaging the transporting safety
device (switch-on lock)
Only activate the changeover switch
(9) when the motor is at a standstill!
Activate the changeover switch (direction of
rotation setting, transporting safety device) (9).
See page 3 (please unfold):
R = right-hand rotation selected
L = left-hand (reverse) rotation selected
0 = central setting: transporting position
(switch-on lock engaged)
7.3 Selecting gear
Do not operate the slide-switch (4)
unless the motor is at a standstill.
Position the slide-switch (4) as required:
= 1st gear (low speed, exceptionally high
torque)
= 2nd gear (high speed)
7.4 Setting torque control, drilling,
impact drilling
Turn selector barrel (torque, drilling, impact
drilling) (2).