Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
d) USB charging port
Always turn off the desired device before connecting it to the USB port.
Make sure the connection is correct. If the product is not connected
properly, it could overheat or cause an electric shock or fire.
Make sure that your device meets the product's power requirements (see
technical data).
• Disconnect the product from the cigarette lighter socket.
• Connect the switched-off USB device to the product. To do so, use a suitable USB
cable (not included).
• Plug the product into the cigarette lighter socket of a vehicle.
• Your USB device is now charging. Should you wish to operate the USB device, you
may turn it on now.
• Turn off the USB device before disconnecting the product from the cigarette lighter
socket.
• Unplug the product from the cigarette lighter socket after use.
You can operate the product while the engine is both on or off. But you
should not start the engine while the product is connected, since the
cigarette lighter socket disconnects during engine start (not necessarily
applicable to all vehicle models). If the engine is switched off, drawing
current over a longer period of time will discharge the vehicle battery.
Troubleshooting
The car radio not transmitting audio can have the following reasons:
• The product has not been properly connected to the cigarette lighter socket.
• The fuse of the product has been activated. Replace the fuse in such a case (see
next chapter).
• A wrong channel has been selected on the car radio. Select the correct channel
(e.g. AUX IN).
• The audio cable is not properly connected with the product and/or car radio.
• The volume of the car radio has been muted.
• You are out of range.
• The Bluetooth
function of your mobile device has been deactivated.
®
• Audio playback has been stopped.
Replacing the fuse
• Screw the protective cap off of the tip of the vehicle plug.
• Remove the contact pin.
• Remove the defective fuse.
• Insert a new identical fuse.
• Reverse the steps to reassemble the car plug correctly.
Maintenance and cleaning
• Besides occasional cleaning, the device is maintenance-free.
• Do not use any abrasive or chemical cleaners.
• Disconnect the product from the cigarette lighter socket before cleaning.
• Also disconnect any USB device connected to the product and all cables before
cleaning.
• Never submerge the product in water to clean it.
• To prevent scratch marks, do not apply too much force on the surface during
cleaning.
• Use a dry, clean, soft and lint-free cloth to clean the housing.
Declaration of Conformity (DOC)
We, Conrad Electronic, Klaus-Conrad-Straße 1, D-92240 Hirschau, hereby declare
that this product conforms to the fundamental requirements and the other relevant
regulations of the directive 1999/5/EC.
The Declaration of Conformity for this product can be found at
www.conrad.com.
Disposal
Electronic devices are recyclable waste and must not be disposed of in the
household waste.
At the end of its service life, dispose of the product in accordance with
applicable regulatory guidelines.
You thus fulfill your statutory obligations and contribute to the protection
of the environment.
Technical data
Input voltage ........................................12 – 24 V/DC
Output voltage/ current ......................5 V/DC, 2100 mA (USB charging port)
Supported standards ..........................SBC, A2DP
Bluetooth
version ..............................4.0
®
Range ....................................................10 m
Cable length .........................................87 cm
Fuse .......................................................2.5 A / 250 V
Operating conditions ..........................0 to +40 °C, 0 – 80 % RH
Storage conditions..............................0 to +40 °C, 0 – 85 % RH
Dimensions (W x H x D)......................37 x 26 x 99 mm
Weight ...................................................35 g
This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com).
All rights including translation reserved. Reproduction by any method, e.g. photocopy, microfilming, or the capture in electronic data
processing systems require the prior written approval by the editor. Reprinting, also in part, is prohibited. This publication represent the
technical status at the time of printing.
© Copyright 2015 by Conrad Electronic SE.
V1_0915_02-ETS-Mkd
Werbung
Inhaltsverzeichnis
