Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Operating instructions
8.89 cm (3.5") SATA hard drive housing USB 3.0
Item no. 1372002 - black / 1372003 - silver
Intended use
The product is intended for installing an 8.89 cm (3.5") SATA hard drive.
It is intended for indoor use only. Contact with moisture, e.g. in bathrooms, must be
avoided under all circumstances.
For safety and approval purposes (CE), you must not rebuild and/or modify this product.
If you use the product for purposes other than those described above, the product may
be damaged. In addition, improper use can cause hazards such as short circuiting,
fire, electric shock etc. Read the instructions carefully and keep them. Make this
product available to third parties only together with its operating instructions.
This product complies with the statutory national and European requirements. All
company names and product names are trademarks of their respective owners.
All rights reserved.
Delivery content
• Hard drive housing
• USB 3.0 cable
• Stand
• Power adapter
Up-to-date operating instructions
Download the latest operating instructions at www.conrad.com/downloads or scan
the QR code on this page. Follow the instructions on the website.
Safety instructions
Read the operating instructions carefully and especially observe the safety
information. If you do not follow the safety instructions and information on
proper handling in this manual, we assume no liability for any resulting
personal injury or damage to property. Such cases will invalidate the
warranty/guarantee.
a) Persons / Product
• The device is not a toy. Keep it out of the reach of children and pets.
• Do not leave packaging material lying around carelessly. These may become
dangerous playing material for children.
• Protect the product from extreme temperatures, direct sunlight, strong jolts, high
humidity, moisture, flammable gases, vapours and solvents.
• If it is no longer possible to operate the product safely, take it out of operation and
protect it from any accidental use. Safe operation can no longer be guaranteed if
the product:
- is visibly damaged,
- is no longer working properly,
- has been stored for extended periods in poor ambient conditions or
- has been subjected to any serious transport-related stresses.
• Please handle the product carefully. Jolts, impacts or a fall even from a low height
can damage the product.
• Also observe the safety and operating instructions of any other devices which are
connected to the product.
• Never move the product during operation with the hard drive installed. Movement
during operation could cause the disk read/write heads to come into contact with
the magnetic disc. This may result not only in data loss but damage to the hard drive.
Switch off the product and wait for at least 30 seconds (until the magnetic discs of
the hard drive have come to a complete stop) before moving the product again.
• Touch only the sides of your hard drive's housing, do not touch the circuit board.
Electrostatic discharges may destroy your hard drive.
• 6x screws
• 4x rubber feet
• Operating instructions
• If the wall plug transformer is damaged, do not touch it; there is danger to life from
electric shock! First, switch off the mains voltage to the mains socket to which the
wall plug transformer is connected (switch off at the corresponding circuit breaker
or remove the safety fuse, then switch off at the corresponding RCD protective
switch, so that all poles of the mains socket are disconnected). You can then unplug
the wall plug transformer from the mains socket. Dispose of the faulty wall plug
transformer in an environmentally friendly way; do not use it any more. Replace it
with a wall plug transformer of the same design.
• The mains outlet must be located near to the device and be easily accessible.
• As power supply, only use the supplied mains adaptor.
• Only connect the power adaptor to a normal mains socket connected to the public
supply. Before plugging in the power adaptor, check whether the voltage stated on
the power adaptor complies with the voltage of your electricity supplier.
• Never connect or disconnect power adaptors if your hands are wet.
• Do not place the product near to speakers or machines that give off a strong
magnetic field.
• Never unplug the power adaptor from the mains socket by pulling on the cable;
always use the grips on the plug.
• When setting up the product, make sure that the cable is not pinched, kinked or
damaged by sharp edges.
• Always lay the cables so that nobody can trip over or become entangled in them.
This poses a risk of injury.
• For safety reasons, disconnect the power adaptor from the mains socket during
storms.
b) Miscellaneous
• Consult an expert when in doubt about operation, safety or connection of the device.
• If you have questions which remain unanswered by these operating instructions,
contact our technical support service or other technical personnel.
Installation
1
3
5
7
2
4
6
2
1
Werbung
Inhaltsverzeichnis
