IROX Mete-On 1 Kurzanleitung Seite 4

View with removed stand and open battery lid
(operate with a thin pin)
2.
Where to place the Mete-On 1
Please place the unit as far away as possible from any potential electric device which may disturb the recep-
tion of the Meteotime signal.
For more information, please take note of the advice provided in the Meteotime brochure «Personal Meteo
Center PMC Important».
The Mete-On  may be hung on a wall or placed on a table. If you place the unit on a table, please use the
provided table stand to assure stability.
3.
Starting-up the Mete-On 1
The Mete-On  may be operated by batteries and/or through the power adapter from the mains. If you are
using the power adapter, we strongly recommend leaving the activated batteries in the unit to prevent a
dataloss in case of a power interruption.
To open the battery lid, please remove the table stand.
In the battery compartment you will find the batteries already inserted, but deactivated by an insulation
strip. Please remove this strip in order to activate the batteries!
4.
Setting the Mete-On 1
After providing power to the unit, you have to enter the basic settings to assure the expected operation
of the Mete-On .
4.1 Select the city for which you wish to view forecasts for
The Mete-On  can give you weather forecasts for up to 90 regions in Europe. To give you an optimal use,
we have preset a total of more than 50 cities located in these 90 regions.
By default, the capital of Switzerland is activated (Bern/Schweiz). You may select at any time another city
by doing the following:
In the basic display, press the «SET» key on the back once. You will now see in the Info window on the
display «SELECT COUNTRY». By pressing the keys (+) or (–) you may scan step by step through the
countries available (in alphabetical order).
As soon as you reach the country of your choice, press the «SET» key. In the Info window you will now see
4
Reset-Contact